--- cristian <
cristianbip@...> wrote:
---------------------------------
>Anything new on the EDM field?
>Cristian
Hi Cristian,
I have now obtained all the components to start
building the EDM + CNC PCB spark eroder.
Hope to have this running in a week or two. I have
used two IPS5751's as I eventually decided that Carl
Richards suggestion of using scr's could wait until
the system is proved. When it is working the I can
think about speed.
When the system is running, (I hope to integrate
stepper increments with spark discharges rather than a
free running spark discharge), I'll put up the
circuit. I think our EDM-PCB guru has gone into
hibernation.
All the best
Roger
Be sure to visit the group home and check for new
Links, Files, and Photos:
http://groups.yahoo.com/group/Homebrew_PCBsIf Files or Photos are running short of space, post
them here:
http://groups.yahoo.com/group/Homebrew_PCBs_Archives/ SPONSORED LINKS
Electrical engineering degree online
Electrical engineering degree
Printed circuit board
Electrical engineering
Electrical engineering course
Electrical engineering graduate school
---------------------------------
YAHOO! GROUPS LINKS
Visit your group "Homebrew_PCBs" on the web.
To unsubscribe from this group, send an email to:
Homebrew_PCBs-unsubscribe@yahoogroups.com Your use of Yahoo! Groups is subject to the Yahoo!
Terms of Service.
---------------------------------
___________________________________________________________
How much free photo storage do you get? Store your holiday
snaps for FREE with Yahoo! Photos
http://uk.photos.yahoo.com