to me, pid controlled laminator is an unbeatable solution.
----- Original Message -----
From: mikegw20
To: Homebrew_PCBs@yahoogroups.com
Sent: Monday, October 17, 2005 8:01 AM
Subject: [Homebrew_PCBs] Ideas (stupid??) for toner transfer
Helo all.
I just had a few random thoughts about toner transfer and I wondered if
anyone has tried them. I am using an iron with a good level of success
as the boards I am using are quite small. However, I read that many
people prefer the laminator to supply heat and pressure.
So I was letting my mind wander with heat and pressure and the thought
about sandwich presses (obviously you would need a flat plate) and
shirt iron presses (I am not sure of the proper name but the things
that iron a whole shirt in one pull of the handle)? The disadvantage
would be the size, but both would require no modification unlike some
laminators.
Has anyone tried either of these two?
Mike
Be sure to visit the group home and check for new Links, Files, and Photos:
http://groups.yahoo.com/group/Homebrew_PCBs
If Files or Photos are running short of space, post them here:
http://groups.yahoo.com/group/Homebrew_PCBs_Archives/
SPONSORED LINKS Electrical engineering degree online Electrical engineering degree Printed circuit board
Electrical engineering Electrical engineering course Electrical engineering graduate school
------------------------------------------------------------------------------
YAHOO! GROUPS LINKS
a.. Visit your group "Homebrew_PCBs" on the web.
b.. To unsubscribe from this group, send an email to:
Homebrew_PCBs-unsubscribe@yahoogroups.com
c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
------------------------------------------------------------------------------
[Non-text portions of this message have been removed]