Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

----- Original Message -----
From: "Radra" <infositeus@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Wednesday, September 28, 2005 6:32 PM
Subject: [Homebrew_PCBs] Pad Cutters Source


> Does anyone have any suggestions where I can obtain a set of pad
> cutters. Would like to be able to cut various size pads on my PCBs.
> One common use will be to isolate pads on the back side of the PCB
> for the occasional thru-hole lead components I use.

Farnell stocks them. Only one size, though.

Leon
--
Leon Heller, G1HSM
leon.heller@...
http://www.geocities.com/leon_heller
---
[This E-mail has been scanned for viruses but it is your responsibility
to maintain up to date anti virus software on the device that you are
currently using to read this email. ]