For cutting PCB then You don´t need the clampingbar, It´s mostly useful when cutting sheetmetal...
----- Original Message -----
From: Stefan Trethan
To: Homebrew_PCBs@yahoogroups.com
Sent: Thursday, September 22, 2005 9:23 AM
Subject: Re: [Homebrew_PCBs] Re: cutting PCBs
On Wed, 21 Sep 2005 22:02:49 +0200, turbojet <turbojet@...>
wrote:
> If You look really good, You´ll se the "clampingbar"´it´s located behind
> the lever...
i have my doubts about the usefulness.
Anyway, my shear has none, and i checked again for tendency of the board
to slide or rotate and there is none.
A clamp could easily be added, but it would obstruct vision.
ST
Be sure to visit the group home and check for new Links, Files, and Photos:
http://groups.yahoo.com/group/Homebrew_PCBs
If Files or Photos are running short of space, post them here:
http://groups.yahoo.com/group/Homebrew_PCBs_Archives/
------------------------------------------------------------------------------
YAHOO! GROUPS LINKS
a.. Visit your group "Homebrew_PCBs" on the web.
b.. To unsubscribe from this group, send an email to:
Homebrew_PCBs-unsubscribe@yahoogroups.com
c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
------------------------------------------------------------------------------
[Non-text portions of this message have been removed]