Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

Well,

I guess I won't have to worry about soldering the components on the
trace side of the board. I just spent about 20 minutes drilling the
holes on both circuit boards. I then went over to fit up some parts
and they hole spacing is off!

To be exact, the whole circuit printout was reduced by 5%, due to a
bug in the software I suspect. I upgraded right after printing out
the transfers I used. Arghhhhhhhhh !

Now I can pretty much bet on the next time around the transfers or
etching or tinning won't come out as nice as these two boards.
Arghhhh, scream!!!!!!!!!!

Is there a club for this sort of problems!

Chris