I attached my bubbler hose to the heater via wire ties so it comes out
when the etching is done. I did it mainly to keep my bubbler where I
wanted it. When i was using CuCl, it would siphon quite readily. I
think it has a much higher capillary action that the others. Almost
like a mind of its own.
--- In
Homebrew_PCBs@yahoogroups.com, "lcdpublishing"
<lcdpublishing@y...> wrote:
> Hi all,
>
> I think I did something pretty stupid again.
>
> My tank is nothing more than a tupperware container - tall and
> skinny. I drilled a hole through the side near the top to pass the
> air hose through. As soon as I turned off the air pump, I realized my
> error - siphoning.
>
> Do you guys leave your air hoses in the tank like this or do you pull
> all the bubbler stuff out when you are done etching?
>
> Chris