| previous by date | index | next by date |
| topic list | next in topic |
Hi
i have just join this group and it is fantastic that there are so many good resources for dw8000 however i am a little disappointed that i was unable to find much stuff info on how to map midi sysex parameters for the dw6000.
i have read the manual and have download Soundquest midiquest librarian demo as well a Crtl panel plugin that converts the midi sysex to cc. but so far have been able to successfully send midi sysex from midi control edirol pcr-m50.
here an example of one of message i have tried sending midi channel 1 F0 42 30 04 41 05 (X) F7 what value should i put in x. if i put a value in x the dw6000 jump to ie 3F and it 63 but there is no range ie turning the knob in either direction (on pcr m50) the dw6000 remained at 63 i tried puting 0-3F for x values but then it just zero, and ignore the 3F. in the manual it talk about bits map and i understand about the offset numbers and how to get the values. but i do not understand about the bits ie cutoff's bit is b5-b0 and the whole bit7 msb to bit 0lsb that has me lost as how to include it in the midi message. any advice or resources would be much appreciated, and once i understand this stuff i will upload a document with all sysex midi for the dw6000 so other can began mapping. thanks regards michael