Is it possible to connect 2 ribbons to one cvs board?
Cheers,
Dennis
--- In ComputerVoltageSources@yahoogroups.com, "djbrow54" <davebr@...> wrote:
>
> I went ahead and finished up my ribbon project. I just had to make the
> interface cable for the RJ-11 connector on the ribbon to my CVS PCB.
> I created a web page with the schematics and program for this project
> at:
> http://modularsynthesis.com/cvs/cvs3.htm
>
> The schematics are the full CVS schematics with the unused parts in
> gray so you can tell what parts are not used.
>
> Dave
>
> --- In ComputerVoltageSources@yahoogroups.com, "djbrow54" <davebr@>
> wrote:
> > No one has mentioned a ribbon controller application. I have done a
> > program that interfaces the Kurzweil PC-2 ribbon to my PSIM and it
> > works pretty good. I bought my ribbon from Sweetwater for $50. I
> > assume they still have them.
> >
> > The program outputs are a CV, trigger, and gate. This can be built
> > in a depopulated CVS pcb and there is a photo in my photo album
> > called "CVS special build configuration". I've got a second ribbon
> > that I was going to use this PCB for, but haven't quite finished
> > yet. Contact me for details if you are interested in building a CVS
> > for a ribbon controller.
>