OK, consider it done. There will be mounting holes on the long vertical edge of PCB for the
MOTM bracket.
--- In ComputerVoltageSources@yahoogroups.com, Henry Till <htill@...> wrote:
>
> On Mar 11, 2006, at 10:28 AM, Grant Richter wrote:
>
> > I think we just plan to rotate the board.
> >
> > For Frac-Rac, the 4 inch is the vertcal dimension, for MOTM, the
> > six inch is the vertical
> > dimension. This why no board mounted pots or jacks.
> >
>
> Sounds good.
>
>
> > Could you explain the different mounting brackets you mentioned or
> > give a link to
> > mechanical drawings?
>
> Here are some pictures of the MOTM Stooge Brackets:
>
> Modular Brackets:
> http://www.wiseguysynth.com/larry/brackets/modular_brackets.htm
> Perhaps Stooge Moe could give us mechanical drawings for these, as I
> don't have any.
>
> The Regular Stooge Brackets (short and long, 3 and four pot):
> http://www.wiseguysynth.com/larry/brackets/4brackets.jpg (picture)
> http://www.wiseguysynth.com/larry/brackets/bracket-draw2.jpg (mech.
> drawing)
>
> (both of these brackets are now sold through http://
> www.stoogeindustries.com, above link just for reference)
>
> So as you can see, using the modular brackets, you can put the
> mounting hole anywhere you please on the main plate, or on the jack/
> pot bracket. I think the plate is about 4 x 6" from the looks of,
> but I haven't purchased any yet, so maybe someone who has one can
> verify this? Moe?
>
> -Henry
>