--- In
AN1x-list@yahoogroups.com, "James Acker" <jacker@o...> wrote:
> I used to morph quite a bit, and even ignored the recent posts on it.(it's been a
little busy here)
>
> And now suddenly....I am not sure what I need to set up in order to morph between
scene 1 and two.
> I know I have both lit, but now when I do it I do not morph...what else do I need to
set up?
>
> Thanks
>
> Jim
>
Scene Control is documented on page 20 of the Owner's Manual. To summarize,
press both SCENE switches - both LEDs should be illuminated; Roll the Mod Wheel to
adjust the balance of Scence 1 relative to Scene 2, .ie., 'morph'.
You can change the physical controller assignment for Scene Control under UTILITY/
SETUP->Ctrl Device->SCENE The default setting is 1:Mod Dpt
Jon