I have different devices (SW1000XG PLG150AN), so I'm not sure wether my
ideas are right.
You don't need hubis loopback (it is usefull to connect different sequencers
or softsynth's)
In general:
connect the controller to PC midi in/ PC midi out to MU100/ MU100 through to
AN1 midi in.
Disable all filters of XG Works.
As far as I know you can choose a part # for plg 150. If you choose part #16
(f.ex.)
then you have to switch the send channel of your midi controller to 16. If
your MU100 is receiving on channel 1 you hve to change the send channel of
your contoller to 1.
if the sounds are ok then record a bulk dump from your controler and save
the sysex messages.
don't forget to check the midi through channel of Xg works. Just try out and
tell me about your efforts.
God luck strong nerves.
Rolf
----- Original Message -----
From: <mark@...>
To: <AN1x-list@egroups.com>
Sent: Sunday, June 25, 2000 6:33 PM
Subject: [AN1x-list] MIDI Connections
> How would I connect the following components?
>
> PC w/MIDI Interface In/Out/Thru
> XG Works 3.0 Software Sequencer
> AN1xEdit
> Hubi Loopback (not sure if I need it)
> MIDI Controller w/MIDI Out only
> AN1x In/Out/Thru
> MU100 w/PLG150-AN In/Out/Thru
>
> I would like to use all these devices at the same time and controlled
> using the MIDI controller.
>
> Thanks in advance,
>
> Mark
>
>
>
> ------------------------------------------------------------------------
> Get a NextCard Visa, in 30 seconds!
> 1. Fill in the brief application
> 2. Receive approval decision within 30 seconds
> 3. Get rates as low as 2.9% Intro or 9.9% Fixed APR
> http://click.egroups.com/1/5197/9/_/663009/_/961950825/
> ------------------------------------------------------------------------
>
> Community email addresses:
> Post message: AN1x-list@onelist.com
> Subscribe: AN1x-list-subscribe@onelist.com
> Unsubscribe: AN1x-list-unsubscribe@onelist.com
> List owner: AN1x-list-owner@onelist.com
>
> Shortcut URL to this page:
> http://www.onelist.com/community/AN1x-list
>