--- In
AN1x-list@yahoogroups.com, DMANX@t... wrote:
> Just in case you did not get my last question, here it is again.
>
Did you not read Gary's reply? This is EXACTLY the post to which
he responded - and I believe he did an exceptional job of trying to
address all your recent points.
You ∗really∗ must take more time to review the replies to your
posts before reposting your questions - this appears to be
nothing more than laziness on your part judging by how often it
occurs.
Furthermore, much of this information is available in the Read
Me files included with AN1xEdit. And if you weren't aware, many
of your SW1000XG/PLG150xx questions are addressed at the
XG Audio Factory web site:
http://www.xgfactory.com/You will find MANY free downloads, FlashROM updaters,
manuals and resources for Cubase, Logic, Cakewalk, etc. there
-- and of course at the PLG150AN page:
http://www.xgfactory.com/html/plg/p150anx.htmand the Yamahasynths Downloads page too:
http://www.yamahasynth.com/down/main.htmThat XG Works XP update mentioned on this list recently can be
had there.
That said...
> I'm having trouble saving newly created voices with added
comments in an1xedit.I have created a new user sequence from
scratch.Not using any exg voices to start of with.Once I created
the voice, I highlight the voice and went to both action/bulk
section (in user mode),and pressed send.Then I pressed store
current under action/bulk section(in user mode) sections,then
saved the file as .anp file.
I assume you are using AN1xEdit in PLG150AN Mode, correct?
This is found under the Setup menu. You find the program will
automatically close the currently active Voice bank when
switching to/from PLG150AN mode. You can only Save an .anp
file while in PLG150AN mode so I assume you've made it this
far.
>I close down anx1edit,then recall it back again, go into user
voices, but cannot find the voice with added comments?
From this description it sounds as though you are not working
with the Voice bank you believe you saved to your hard drive. Are
you ∗certain∗ you gave the Voice bank an independent name and
saved it accordingly with the .anp suffix?
>But I know which user voice number it is,so I highlight it,click on
send under action/bulk, but here a difrent voice,so I refresh synth
still here a diffrent voice.
This all but confirms you are NOT working with the Voice bank
you believe you saved as an .anp file.
>So I have to hit send and refresh a number of times till the
voice I created comes back.
It sounds as though the Refresh command is being issued from
an ∗empty∗ Voice bank against your PLG150AN and eventually
the 1st edit you 'stored' in the User program location is being
recalled, i.e. refreshed.
>But still with no name or comments on the patch?
Becuase it's not the Voice bank you believe you saved as an .anp
file.
> Were am I going wrong?
You are not working with the Voice bank you believe you saved
as an .anp file.
> I also heard that you can send sounds of the an150 to XG
effects.How is this done,or am I getting cofused.
>
You'll find loads of info regarding the SW100XG and many
tutorials at the XG Audio Factory web site.
I believe you should get past saving and recalling your files in a
predictable manner and demonstrating that you acknoweldge
and understand the replies you receive to your posts before you
advance to more complicated subject matters.
Furthermore, this is not an SW1000XG support group so
SW1KXG answers from list members may not be forthcoming
(particularly since is the third time this post has made it to the list
and no one has taken up the question yet...)
Jon