--- In AN1x-list@y..., mattias.karlsson@s... wrote:
> Hi!
>
> Not to brag but I have a quite big MIDI-system. I try not use to much
> MIDI-filtering as I have a quite old MIDIpatchbay. However I've ran
> into some troubles when using my An1x. I can't seem to turn of it's
> habit of sending program change (and occasionally control change).
>
> So when I switch program on the An1x so do another six synths. Is
> there a way to switch it off?
>
There's no method to disable Program Change commands on the AN1x.
you'll need to filter the messages either at your MIDI Patch Bay or on
the remote modules/synths.
However, you can disbale MIDI Change Control's from being trasmitted.
Go to the UTITLITY/SETUP menu and use the [Ctrl Device] to select which
real time controller you wish to disable and use [Ctrl No] to select
'0: off' as the value.
The problem with this solution should be obvious: What to do when you
WANT to send MIDI CC's from the AN1x? A possible solution is to use the
[BulkDump] command and select the 'system' options to dump only those
settings to a generic MIDI SysEx librarian which can then be reloaded
as necessary. This also allows for storing multiple Assign Knob
configurations as seperate SysEx dumps which allows you to work around
the limitation of only one set of Assign Knob settings available at any
one time.
Personally, I don't care for this solution - too labor intensive to
keep organized. I've taken to leaving the AN1x default values in place
and creating customized Environment Layers within Logic Audio to
perform MIDI CC routing and/or filtering. I recommend you pursue a
similar option or resort to filtering at your MIDI Patch Bay.
regards,
Jon