Hi Paul,
Hmmm...strange indeed!
In practice the PLG150AN does not respond to CC7 (or XG MultiPart volume
sysex for that matter). It is normally the host device that responds to
this command (in the case of the SW1000XG it is its onboard mixer for
the relevant Part audio return signal). If you want to control the real
volume output of the PLG150AN, you should send the sysex command for VCA
Volume!
I think the PlgStation cannot behave similarly to other XG host devices,
since it has no fixed mapping (or logic) between parts/Midi channels and
its on board mixer.....it only knows about PLG slots. Hence the only
solution is to use its mixer sysex command ;-(
I am not entirely sure what it means that the CC7 is filtered? I wonder
whether it actually does get to the PLG board? If it does you could
always use the voice Matrix to map CC7 to VCA volume!
Regards
Gary Gregson
Email:
gary@...http://www.yme.co.uk/yme -----Original Message-----
From: Paul Murphy [mailto:
merfman@...]
Sent: 12 October 2001 11:55
To:
AN1x-list@yahoogroups.comSubject: Re: [AN1x-list] Gary G - what u think of KENTON's CC7 killer ?
Gary,
In all your wisdom as a genius midi programmer, I would like to ask your
opinion of KENTONs decision to kill CC7.
I bought my KENTON home, hooked it up, and was pleasantly surprised by
the
new life it brought to my PLG150AN. Happily tweaking the filter cutoff
and
resonance controls on my Phatboy, I then tweaked the volume knob and
scratched my head for 10 mins trying to figure out why it did nothing ?
Was my Phatboy busted ? no - the vol knob worked on the SW1000XG, so it
must be a KENTON issue. I opened the manual and was absolutely
astounded to
read that they filter it out to avoid confusion with thier SYSEX
parameter
that controls the volume on thier own mixer.
In the case of the PLG150AN being connected to the SW1000XG, I would
imagine
that the PLG itself responds to CC7 or the SW1000XG does by adjusting
the
return path volume on the PLG cards output.
So why doesnt the plugstation do the same ? eg - either send the CC7 to
the
PLG, or map CC7 to its own mixer. As an end user I dont care which as
long
as my volume knobs work.
I'm still having trouble coming to grips with KENTONS logic of this so I
have emailed them but Im also wondering if its me going mad or if you &
other users are in agreement with me.
----- Original Message -----
From: Gary Gregson <gary@...>
To: <AN1x-list@yahoogroups.com>
Sent: Friday, October 12, 2001 8:09 PM
Community email addresses:
Post message: AN1x-list@yahoogroups.com
Subscribe: AN1x-list-subscribe@yahoogroups.com
Unsubscribe: AN1x-list-unsubscribe@yahoogroups.com
List owner: AN1x-list-owner@yahoogroups.com
Shortcut URL to this page:
http://groups.yahoo.com/group/AN1x-list
Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/