previous by date | index | next by date |
previous in topic | topic list | next in topic |
----- Original Message -----
From: "Gary Gregson" <gary@...>
To: <AN1x-list@yahoogroups.com>
Sent: Friday, July 06, 2001 10:16 PM
Subject: RE: [AN1x-list] Reverb/Delay send
> Hi Paul,
>
> All of the An1x effects are inline inserts (although the Delay and
> Reverb can be switched to operate either in parallel of series). Hence
> there is no SEND level....since the entire signal actually goes through
> the effect unit! As such the RETURN parameter should really be called
> DRY/WET; since it really controls the proportion of dry (unaffected)
> versus effected signal being returned.
>
> In addition you can choose to bypass each effect (FX BYAPASS). You
> should note that this is a 'system' parameter so cannot be saved with
> each patch (it is intended as a quick switch, so you can disable effects
> whilst experimenting with raw voice parameters).
>
> You should be careful when using the MATRIX to control parameters. The
> matrix is designed for applying real-time performance control to a
> patch....it is not for setting the default parameters of a patch! As
> such, the matrix merely maps external controllers to internal
> parameters. The resultant controller values are added (or multiplied) to
> the current patch programmed values (i.e. they are applied as offsets).
> When you save a patch, only the programmed value is saved....not the
> value plus controller offset!
>
> Hence if you have set up a RETURN level and then use the Matrix to apply
> a controller offset to the RETURN value, you will hear the set value
> plus the offset. However if you store the patch, you will only store the
> set value. Consequently on reload the patch will re-use the set value
> (without the offset).
>
> Regards
>
> Gary Gregson
>
> Email:gary@...
> http://www.yme.co.uk/yme
>
> -----Original Message-----
> From: Paul Nagle [mailto:paul@...]
> Sent: 06 July 2001 19:17
> To: AN1x-list@yahoogroups.com
> Subject: [AN1x-list] Reverb/Delay send
>
> Anyone know how to set reverb and delay SEND amounts in a patch? I
> have these as two assignables all the time but whenever I alter them
> and save the scene and then the patch, when I reload the patch the
> send levels are much higher than I programmed.
> In the programming matrix I can set RETURN levels but not send. What
> silly little thing am I missing?
>
> Cheers,
>
> Paul
>
>
>
>
> Community email addresses:
> Post message: AN1x-list@yahoogroups.com
> Subscribe: AN1x-list-subscribe@yahoogroups.com
> Unsubscribe: AN1x-list-unsubscribe@yahoogroups.com
> List owner: AN1x-list-owner@yahoogroups.com
>
> Shortcut URL to this page:
> http://groups.yahoo.com/group/AN1x-list
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>