Archive of the former Yahoo!Groups mailing list: The Yamaha AN1x Synthesizer mailing list

Are 850Mhz CPU's too fast for Hubi's (16bit) and Midi Yoke(32bit)
therefore causing some of the data to get lost or truncated? Because
I have been battling to get the PLG150AN to load up properly going on
2 months now. So far I've got it down to this ...With An1xEdit in
PLG150AN mode, An1xEdit using Hubi's LB1 out.... an instance of
hwmdcabl.exe with LB1 in ...SW1000XG#1 out. I double-click a voice
from the "Yamaha_Best_Of.an1" voice list, I either get no sound or a
completely different sound from the intended sound. I can verify this
by choosing SW1000XG#1 as the output of AN1xEdit ...double-click any
voice and it sounds correct. I've tried refreshing the XG device from
XGedit first and then refreshing the PLG150AN from the An1xEdit with
no luck. MidiYoke tends to detune everything or simply messes up the
voice so badly that its not recognizable. I've monitored this with
MidiOx (LB1,MidiYoke1.... separately) and I can see all the Hex. I
wish there was some way to see the Hex going into the SW1000XG#1
driver but AFAIK there are no tools for the "layman" to see this data
for comparison purposes. I would sure like to be working on
my "chops" rather than fighting these kinds of problems. I'm trying
to get some "repeatability" here because there is nothing worse than
spending hours tweaking a masterpiece...saving it ...recall
it ...doesn't even remotely sound like what I had saved if I'm using
Hubi's or MidiYoke. I sure wish someone could help me with these
issues for it would be GREATLY appreciated.

Thanks for reading this message,

Gary Osborne


Celemine 566@850
256Meg Ram
Windows 98,98SE,ME (Does the same thing in all these OS'es)
Latest firmware/drivers from Yamaha..SW1000XG Only.
Logic Audio 4.5(Win)
Hubi's v2.5
MidiOx 6.0.5
MIDI-Yoke 1.61/1.56