Of course you can change all these parameters with MIDI.
Look in MIDI Data Table <1-3> "MIDI Parameter Change Table (Current
Voice Common Buffer" on page 14 of the Data List manual.
Tidda
--- In AN1x-list@yahoogroups.com, Jeff <jf.serviere@...> wrote:
>
> Hello !
> as far as i know the effects section parameters are not addressable by
> MIDI but can only be assigned to the own controls of the AN1x (pots,
mod
> wheel and so on...) . It has to be done for each patch . I use to
> control the "leslie" speed with the mod wheel and the reverb and delay
> with 2 knobs, i never tried the ribbon controller (used mostly to
> control the cutoff and resonance of the filter together). The pedal
> controller (neither the footswitch nor the volume) should work too .
> OK, this cannot be done by a software sequencer ....
> @+
> J.F.
>
> thilo_78 a écrit :
>
> >Hello,
> >
> >I would like to control some parameters of the effects-section via
> >Midi. For example I would like to control Delay's "FB-Level" or "Delay
> >Return", "Reverb Return" etc.
> >In the Midi-Control Chart I did not find an entry. Is there a
> >possibility to control these parameters (e.g. by routing it to ribbonX
> >or another controller; or via sysex messages)??
> >
> >Thank you very much and kind regards,
> >
> >Thilo
> >
> >
> >
> >
> >
> >---
> >avast! Antivirus: message Entrant propre.
> >Base de donnÚes des virus (VPS): 000729-2, 31/03/2007
> >Test du: 02/04/2007 00:42:27
> >avast! - copyright (c) 2000-2007 ALWIL Software.
> >http://www.avast.com
> >
> >
> >
> >
> >
>
>
>
> ---
> avast! Antivirus: message Sortant propre.
> Base de donnÚes des virus (VPS): 000729-2, 31/03/2007
> Test du: 02/04/2007 01:08:14
> avast! - copyright (c) 2000-2007 ALWIL Software.
> http://www.avast.com
>