--- In
AN1x-list@yahoogroups.com, "Jon" <jondl_2000@...> wrote:
>
> --- In AN1x-list@yahoogroups.com, "lou.kadassy" <lou.kadassy@> wrote:
> >
> > --- In AN1x-list@yahoogroups.com, "Jon" <jondl_2000@> wrote:
> > >
> > > --- In AN1x-list@yahoogroups.com, "lou.kadassy" <lou.kadassy@>
wrote:
> > > > I thought it would be easy to use a footswitch to, ahem, "switch"
> > > > between scenes, but I haven't been able to do that.
> > > >
> > > > My question is: can I use a foot switch (or continuous foot
> > > > controller, aka volume pedal) to switch between scene 1/2? I don't
> > > > want to morph, I just need to switch.
> > > >
> > > > Any help would be appreciated.
> > > >
> > > > Lou
> > >
> > > Yes, to both.
> > >
> > > On the AN1x, set the [EDIT ROTARY] Knob to the UTILITY/SETUP menu.
> > >
> > > Press Ctrl Device until you see FS displayed.
> > >
> > > Press Ctrl No to change the value to 3: SceneSel
> > >
> > > Press Ctrl Device until you see SCENE displayed, the Ctrl No value
> > should also be 3:
> > > SceneSel. If it's not, press Ctrl No to change the value to 3:
SceneSel.
> > >
> > > Play your sound, presee the Foot Switch (FS) to hear the 2nd Scene,
> > release to hear the 1st
> > > Scene. There is no Morphing invoked when using FS.
> > >
> > > Repeat the above procedure for using a Foot Controller (FC).
> > Obviously, Morphing can be
> > > used with FC and you can have both FS and FC available
> > simultaneously. Might get
> > > confusing if you use the AN1x as a Master Control Keyboard ;-)
> > >
> > > Hope this helps.
> > >
> > > Regards,
> > >
> > > Jon
> > >
> >
> > Jon,
> > many thanks for your response.
> >
> > Unfortunately, it doesn't work as I expected. Did all the steps but
> > when I press the switch ∗both∗ scene lights go on and I listen to a
> > mix between the two.
>
> It works just fine here.
>
> Select both Scene switches so they are active and try again. Make
certain the Layer value
> for your Voice is Single. I'm using a Yamaha FC-5 Square Style Foot
Switch Normally
> Closed.
>
> Jon
>
You're right, Jon! It works beautifully.
The only downside is that ∗both∗ scene lights are lit all the time so
I can't tell which one is selected.
Probably a momentary switch (as you suggested earlier) is a good idea
after all. Push for scene 2, release for scene 1.
Thanks to everybody for their help,
Lou