<div dir="auto">I believe the schematic indicated is completely workable. Minimoog service documents are easily found online, if you wish to further reassure yourself of it's basic design. <div dir="auto"><br></div><div dir="auto">I believe Transistor choice should not prevent a ladder filter from functioning. </div><div dir="auto"><br></div><div dir="auto">At least, I've built basic ladder filters with unmatched 2n3904/6's and they sounded fine. </div><div dir="auto"><br></div><div dir="auto"><br></div><br><br><div class="gmail_quote" dir="auto"><div dir="ltr" class="gmail_attr">On Sat, Jun 10, 2023, 12:15 AM David G Dixon via Synth-diy <<a href="mailto:synth-diy@synth-diy.org">synth-diy@synth-diy.org</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><u></u>



<div>
<div><span>Hello SDIY Team,</span></div>
<div><span></span> </div>
<div><span>I've built a ladder filter on my own 
PCB layout from Yves Usson's Minimoog ladder filter schematic, and I must 
confess that the results are less than stellar.  The filter works, but 
not terribly well, and it sounds nothing like a Minimoog.  I 
used 2N3904 and 2N3906 instead of BC547 and BC557, but I matched all of the 
transistor pairs in the ladder, and matched the four transistors at 
the top and bottom of the ladder as well as the other four transistors, 
using Ian Fritz's transistor matching circuit (which I also laid out and built 
on a PCB).  I did not try to match the one PNP to the current driving NPN 
below the bottom of the ladder.</span></div>
<div><span></span> </div>
<div><span>Does anyone here have any experience with 
this schematic?  Will it change anything if I replace the 3904s with 547s, 
etc?  Everything else was exactly as specified in the schematic.  This 
was my second attempt to build from an Yves Usson ladder filter 
schematic.  My "Raging Bull" Taurus filter didn't work at all.</span></div>
<div><span></span> </div>
<div><span>I just want to know if there is some 
fundamental flaw in this schematic before I spend too much more time with 
it.  Any insights would be most appreciated.</span></div>
<div><span></span> </div>
<div><span>Dave Dixon</span></div></div>
_______________________________________________<br>
Synth-diy mailing list<br>
<a href="mailto:Synth-diy@synth-diy.org" target="_blank" rel="noreferrer">Synth-diy@synth-diy.org</a><br>
<a href="http://synth-diy.org/mailman/listinfo/synth-diy" rel="noreferrer noreferrer" target="_blank">http://synth-diy.org/mailman/listinfo/synth-diy</a><br>
Selling or trading? Use <a href="mailto:marketplace@synth-diy.org" target="_blank" rel="noreferrer">marketplace@synth-diy.org</a><br>
</blockquote></div></div>