<div dir="ltr"><div>I've been working on these for twenty years, and thought I'd seen pretty much everything that could go wrong with them.</div><div>Now, I have one that works perfectly except for the fact that it will not go through the tune procedure, either at powerup or when the Tune button is pressed.</div><div><br></div><div>The confusing part is that the fault has been narrowed down to the voice board: if I swap in a working voice board, the unit functions correctly; if I install this voice board in another unit, the problem follows.</div><div><br></div><div>As far as I can see, the ONLY parts on the voice board that relate to tuning are the two 4051 multiplexers (U423 and U428) and the LM311 comparator (and its associated resistors & caps). All of these components have been replaced; traces and resistors have been checked &  measured. All traces to the 60 pin connector between the CPU and Voice boards are good, as is the 60 pin cable.<br></div><div>EVERYTHING is there, and everything works correctly except for Tune.</div><div><br></div><div>I've been hitting my head against this for a couple of weeks, and would appreciate any suggestions as to where to look.</div><div><br></div><div>Thanks.</div><div>~GMM<br></div></div>