<div dir="ltr"><div dir="ltr">On Thu, 23 Feb 2023 at 00:38, Neil Johnson via Synth-diy <<a href="mailto:synth-diy@synth-diy.org">synth-diy@synth-diy.org</a>> wrote:<br></div><div class="gmail_quote"><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><br>In a bipolar system the only current that flows in the ground is the<br>
balance current, which is the difference between the currents in the<br>
positive and negative rails.  Ideally this balance current is 0.<br></blockquote><div><br></div><div>Would it be worthwhile to completely avoid using the ground for anything else than a signal ground reference, and power all current-drawing circuits from the +/- supplies? If ground would be needed here, it would be a buffered ground created by an op-amp buffer that draws its currents from the +/- supplies, not from the ground it buffers. (Does anyone do it like this?) :-)</div><div><br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">
As Roman suggested earlier IIRC, a much better way to drive LEDs is a<br>
constant current chain between the two supply rails, with switches<br>
(electronic or mechanical) across the LEDs to short them out when you<br>
want them off.  This has two distinct advantages:<br>
1) it keeps the current draw constant, so no sharp edges of current on<br>
the power lines;<br>
2) it keeps noise out of the common ground line.<br></blockquote><div><br></div><div>Is there any recommended go-to circuit design for implementing a good simple constant-current LED driver (preferably one with CV control of brightness as well, for non-binary indication)? Feels like important circuits like this would be great to have "standardised" in the community. Oh, I'm then assuming a 25yr+ EE design that is guaranteed to be "better", not the "bad" ones that other people rave about.  O;-)</div><div><br></div><div>The constant-current designs for LED-bar level meters found in mixing console schematics are nice, perhaps the simpler circuits above are hiding there as well?</div><div> </div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">There is a veritable treasure trove of design knowledge in the form of<br>
analogue mixing desk schematics and service manuals.  Hundreds of<br>
them, from Mackie, AHB, Soundcraft, Neve, SSL, Studer, DDA, and so on.<br>
Many of them can be found with a little bit of googling.  And you'll<br>
see how to switch LEDs quietly, how to power opamps for low noise, and<br>
how to distribute power in a large bussed audio system.</blockquote><div><br></div><div>Darn, need to switch (silently!) to googling instead... :-) </div><div><br></div><div>/mr</div><div><br></div></div></div>