<div dir="ltr"><div>Thanks for the reply.</div><div><br></div>These are all SMD components and the capacitor is labeled C65 so I'm 99% sure it is a ceramic capacitor. There is an "output stage" for each of the power rails and each one has a similar layout. All three have a resistor and capacitor placed vertically just before an inductor. The -12V rail is the only one that seems like it is shorted to ground when doing a continuity test with the meter. The resistor and capacitor in question are between the mosfet and diode though (really big ones) and desoldering them will prove to be a challenge. I would rather have some confirmation that they are indeed the problem before trying to get them out of the hole they are in.</div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Wed, Feb 15, 2023 at 7:36 PM <<a href="mailto:mskala@northcoastsynthesis.com">mskala@northcoastsynthesis.com</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">On Wed, 15 Feb 2023, Shawn Rakestraw via Synth-diy wrote:<br>
<br>
> I found a ceramic capacitor between the mosfet and rectifier that seems<br>
> shorted, but I don't know if there is another part of the circuit causing<br>
> that or not. And I haven't tried removing the cap yet to test it off the<br>
> board.<br>
<br>
Are you sure that's a ceramic capacitor and not a polyfuse?  They often<br>
look similar, and the polyfuse will read as a low resistance.<br>
<br>
-- <br>
Matthew Skala<br>
North Coast Synthesis Ltd.<br>
</blockquote></div>