<div dir="ltr">Anyone on the list have insight or advice on getting Ensoniq gear to pass the keyboard calibration routine?  I'm looking at an ASR10 at the moment.  Cleaned the PCBs, resoldered the connectors (the only advice I've seen online), and checked continuity everywhere relevant I could think of.  No dice.  I haven't seen any in depth guide to dealing with this online aside from the "one simple trick" of resoldering the connector.  <div><br></div><div>Ensoniq was very stingy with schematics but the keyboard section is posted here:<div><br></div><div><a href="http://www.tauntek.com/ASR10.htm">http://www.tauntek.com/ASR10.htm</a><br><div><br></div><div>Any input would be greatly appreciated.  Thanks!</div></div></div></div>