<div dir="ltr">lots of designers have used CD4000 series CMOS in SDIY circuits successfully.  they have their place if used properly, and their limitations (like every technology).  would be a shame if a newcomer were to be scared off of perfectly good parts just because you couldn't get it to work in your application.  <div><br></div><div>bbob drake</div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Fri, Sep 17, 2021 at 2:52 PM David G Dixon via Synth-diy <<a href="mailto:synth-diy@synth-diy.org">synth-diy@synth-diy.org</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">So, I went to the lab and set up a little breadboard.  I put 4024 on it,<br>
used my +15V and 0V rails to power it (yes, I decoupled with 104), and I<br>
also set up a TL072 as a comparator driven by a triangle-wave LFO.  I sent<br>
the output of the comparator through a diode to have it go just between 0V<br>
and +15V.  I tried clocking two CD4024BEs, two CD4024BCNs, and one<br>
MC14024BCP.  The CD4024BCNs didn't even work.  The CD4024BEs gave me some<br>
really hashy looking outputs.  The MC14024BCP worked perfectly.  Then I<br>
tested them in an ASR, with similar results.<br>
<br>
So, I threw all of the CD4024s into the trash.  Unfortunately, I only have<br>
one MC14024B.  I'm going to buy more, cuz they work well, without any<br>
issues.<br>
<br>
Lesson learned, I guess.  I'm just not sure what the lesson is, other than<br>
"don't use CD4XXX chips" or at least ones with edge-driven inputs.<br>
Argghh!!!  Why can't this stuff just work?  It's a miracle that we aren't<br>
still living in caves, wearing skins and hunting sabre-tooth tigers with<br>
sticks.<br>
<br>
_______________________________________________<br>
Synth-diy mailing list<br>
<a href="mailto:Synth-diy@synth-diy.org" target="_blank">Synth-diy@synth-diy.org</a><br>
<a href="http://synth-diy.org/mailman/listinfo/synth-diy" rel="noreferrer" target="_blank">http://synth-diy.org/mailman/listinfo/synth-diy</a><br>
Selling or trading? Use <a href="mailto:marketplace@synth-diy.org" target="_blank">marketplace@synth-diy.org</a><br>
</blockquote></div>