<div dir="auto"><span style="word-spacing:1px;color:rgb(49,49,49)">One of the reasons we were using Indium in our application was that it remains soft and can take up the difference when bonding materials with CTE mismatches. We were soldering glass-like materials to copper.</span></div><div dir="auto"><span style="word-spacing:1px;color:rgb(49,49,49)"><br></span></div><div dir="auto"><span style="word-spacing:1px;color:rgb(49,49,49)">We were operating at cryogenic temperatures, so the huge swings from 77K to room temp would eventually fatigue the solder joint, but they typically lasted several months of daily temperature cycles. </span><br></div><div dir="auto"><span style="word-spacing:1px;color:rgb(49,49,49)"><br></span></div><div dir="auto">On Tue, Aug 17, 2021 at 5:54 PM Gordonjcp <<a href="mailto:gordonjcp@gjcp.net">gordonjcp@gjcp.net</a>> wrote:<br></div><div><div class="gmail_quote"><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left-width:1px;border-left-style:solid;padding-left:1ex;border-left-color:rgb(204,204,204)" dir="auto">On Tue, Aug 17, 2021 at 03:59:49PM +0200, cheater cheater via Synth-diy wrote:<br>
> <br>
> <br>
<br>
I don't know about the difference in thermal conductivity, but for this bit you might want to consider getting the heatsink good and hot in an oven.  Do it slowly and let it get to an even temperature right through.<br>
<br>
Also consider that the dissimilar metals will expand and contract at different rates, and it might just crack itself free after a few cycles of heating and cooling.<br>
<br>
-- <br>
Gordonjcp<br>
<br>
_______________________________________________<br>
Synth-diy mailing list<br>
<a href="mailto:Synth-diy@synth-diy.org" target="_blank">Synth-diy@synth-diy.org</a><br>
<a href="http://synth-diy.org/mailman/listinfo/synth-diy" rel="noreferrer" target="_blank">http://synth-diy.org/mailman/listinfo/synth-diy</a><br>
Selling or trading? Use <a href="mailto:marketplace@synth-diy.org" target="_blank">marketplace@synth-diy.org</a><br>
</blockquote></div></div>