<div dir="ltr"><div dir="ltr"><br></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Thu, May 27, 2021 at 1:58 PM Tim Parkhurst via Synth-diy <<a href="mailto:synth-diy@synth-diy.org">synth-diy@synth-diy.org</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><div dir="ltr"><div dir="ltr"><div dir="ltr">Has anybody tried using aluminum PCBs as panels? There's an informative thread about it here:<div><a href="https://modwiggler.com/forum/viewtopic.php?t=180347&sid=cb70d7a755740e33b2aaee77ec6068e5" target="_blank">https://modwiggler.com/forum/viewtopic.php?t=180347&sid=cb70d7a755740e33b2aaee77ec6068e5</a><br></div><div><br></div><div>And the manufacturer of choice seems to be PCBWay:</div><div><a href="https://www.pcbway.com/" target="_blank">https://www.pcbway.com/</a></div></div></div></div></blockquote><div><br></div><div>I should probably try PCBWay before I give up entirely, but I tried this with some aluminum PCB material at AllPCB and the results were not good.  Mounting holes were rough, but more importantly, slikscreen directly on the raw aluminum panel did not work very well.   Not sure if I still have my examples around or if I just chucked them.  Silver was what I was going for, I suppose if I were to go with colored solder mask and silkscreen onto that it would probably be OK.  At that point I'm not sure the extra cost for aluminum is justified though; I've seen a lot of very nice FR4 panels.  My favorite was the one where the designer of an alternate panel for Rings put the Lord of the Rings tree circled by the engraving of the one ring in copper under the soldermask, so it's just raised a bit.  Looks really sharp.</div><div><br></div><div>Pete</div></div></div>