<div dir="ltr"><div>Thanks for the comments and general direction. I believe you and genuinely hope that it is a solder joint. That would be a simple fix by relowing the joints. I can't help but wonder, would a cold solder joint suddenly form after 15 years of use and also never being moved for 10 years? I tried checking the noise floor (with my ears) and it seemed the same for both monitors. Maybe it is the input signal. I will investigate more!<br></div><div><br></div><div><br></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Thu, Nov 19, 2020 at 3:34 PM The SynthiMuse <<a href="mailto:synthimuse@gmail.com">synthimuse@gmail.com</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><div dir="auto"><div>If you listen to the monitors with no input signal and check if the small amount of noise is the same for both monitors then that implies that there's a bad connection or solder joint on the input signal. On the other hand, if you hear the backgtound noise profile tracks the previously heard behaviour on the suspect monitor,  that might suggest an issue further up the chain on the power amp end.</div><div dir="auto">Jimmy Moore's suggestions are good and it helps to have a known good working channel to compare measurements with.</div><div dir="auto"><br></div></div>
</blockquote></div></div>