<div dir="ltr">Hi folks!<div><br></div><div>After dedicating some time to this project, my very own Memorymoog clone is nearly completed! Still missing the buttons, so far the 3D printed attempts turned out bad. Also, the 9mm thickness aluminum side cheeks are not done, as well as adaptors for the dual concentric frequency potentiometer knobs.</div><div><br></div><div>It seems to be more stable than the old Memorymoog I used to own a couple decades ago - no autotune update on that unit, which is built into my clone. I get "6 tuned" at pretty much every attempt, as long as I allow for some 15 to 20 minutes warmup.<br></div><div><br></div><div>The sound is, as far as I can tell, exactly the same as a stock Memorymoog: all circuits are exactly the same.</div><div><br></div><div>I tested several LEDs to decide on a color, and figured the diffuse white looked better than the original red ones.</div><div><br></div><div>Cheers!</div><div><br></div><div><img src="cid:ii_kgayaote0" alt="20201014_180145-1328.jpg" width="542" height="305"><br></div><div></div></div>