<div dir="ltr">There are some commercial modules using this approach. The cheap module lines from Dreadbox used PCB panels (I'm not sure about their latest colorful series). Makenoise has used them in some devices too, I believe.<div>They are not as durable as aluminum, for sure, but then again, you'd expect most users won't drop their modules on the floor. Even if they do, though, a replacement PCB panel is very cheap.</div><div>They are a bit on the bendy side, so big panels with push switches would need some consideration - still, much cheaper than getting an aluminum panel of the same size and visual quality.</div><div>For DIY especially, I don't see anything wrong with using them, to be honest.</div><div><br></div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Wed, Oct 14, 2020 at 6:19 PM Didier Leplae via Synth-diy <<a href="mailto:synth-diy@synth-diy.org" target="_blank">synth-diy@synth-diy.org</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">This may be slightly off topic, but how do people feel about PCBs as front panels? So far this has been how I have been doing it. I guess it’s not ideal, but the results are decent and quite cost effective when making small quantities.<br>
Are there ways to make metal face plates in small quantities that are affordable?<br>
<br>
<br>
> On Oct 14, 2020, at 9:49 AM, Neil Johnson <<a href="mailto:neil.johnson71@gmail.com" target="_blank">neil.johnson71@gmail.com</a>> wrote:<br>
> <br>
> <br>
> One good source for learning are the front panels of good quality test equipment, from the likes of HP, Tektronix, Fluke, Philips.  Companies that have entire departments responsible for the ergonomics/"man-machine-interface" (or Human Factors as it used to be called).<br>
> <br>
> Neil<br>
> _______________________________________________<br>
> Synth-diy mailing list<br>
> <a href="mailto:Synth-diy@synth-diy.org" target="_blank">Synth-diy@synth-diy.org</a><br>
> <a href="http://synth-diy.org/mailman/listinfo/synth-diy" rel="noreferrer" target="_blank">http://synth-diy.org/mailman/listinfo/synth-diy</a><br>
<br>
<br>
_______________________________________________<br>
Synth-diy mailing list<br>
<a href="mailto:Synth-diy@synth-diy.org" target="_blank">Synth-diy@synth-diy.org</a><br>
<a href="http://synth-diy.org/mailman/listinfo/synth-diy" rel="noreferrer" target="_blank">http://synth-diy.org/mailman/listinfo/synth-diy</a><br>
</blockquote></div>