<div dir="ltr">I'm working on laying out a classic through hole module design with SMD parts.  The original uses a fair number of resistor networks, most of them just parallel resistors, not common bus versions.  The resistor networks are, well... huge by comparison.<br><br>Unfortunately the original designer isn't around for me to ask for input.<br><br>My *impression* based on how the networks are being used (often times for things like input resistors and a feedback resistor in a summing op amp config, just as one example) is that part of their purpose was to get parts that were well matched.  But that's not anything but a gut feeling.<div><br>So I'm looking for seasoned opinions about whether there is any important reason to keep resistor networks, when I can sub in 1% SMD parts that will take up less space and be more flexible for placement.  Are the networks either 1) better matched even than 1% parts, or 2) have some other characteristic which I'm not thinking of that might be important?<br><br>Thanks<br><br>Pete</div></div>