<div dir="ltr"><div dir="ltr">On Tue, 4 Aug 2020 at 23:16, Mike Beauchamp <<a href="mailto:list@mikebeauchamp.com">list@mikebeauchamp.com</a>> wrote:<br></div><div class="gmail_quote"><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">On 8/3/20 8:11 AM, Mattias Rickardsson wrote:<br>> ...<br>
> Btw, TL064s are hardly visible in the heat camera - they pull so little <br>
> current. Applying TL064 op-amps where noise & slewrate aren't critical <br>
> factors is an important trick in designs where power & heat & cost are.<br>
> ...<br><br>
Thanks Matthias, I appreciate the reply and reassurance. Interesting <br>
about the TL064, I've never heard of the chip before. </blockquote><div><br></div><div>Oh, I thought the "precision" TL05x series were the unknown ones in the family. :-) (Does anybody use them?) The TL06x are the low-power ones, and the TL07x & TL08x are the twins separated at birth that nobody seems to know if they are identical or not.</div><div> </div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">It might be useful <br>
in some CV-summing and other non-audio sections, although taking a squiz <br>
at the datasheet it can only handle within +/-4V of each rail? (so +/- <br>
8V on your case with the 12V bipolar supply?). </blockquote><div><br></div><div>You must be referring to the Common Mode Voltage spec? </div><div>And it seems you're looking at the Recommended Operating Conditions, where they for some reason exaggerate things from the Electrical Characteristics section a bit.</div><div><br></div><div>Ordinary inverting op-amp stages have zero common mode voltage, so it's normally not a problem. But in voltage followers it's important that the common mode voltage doesn't reach close to the negative supply, or the op-amp will show phase-reversal and possibly latch-up. Note though that this is the same for TL07x, so you already have the issue there - check out the datasheet! :-)</div><div> </div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">It's easy enough to drop <br>
in on my PCB to see. I don't need to reduce the current and temperature <br>
now that I am no longer worried about it, but it would be nice to be a <br>
bit easier on the power supply. I am using TL074's pretty much <br>
everywhere to keep my BOM simple, and I have hundreds of them on-hand. <br>
But clearly they use a lot more power than I expected!<br></blockquote><div><br></div><div>It's a bit annoying that op-amps often need much more current just to function internally than they deliver to the outer world even at full force and heavy load in our typical synth circuits. :-)</div><div><br></div><div>/mr</div><div><br></div></div></div>