<div dir="auto"><div><div class="gmail_quote"><div dir="ltr" class="gmail_attr">Hi Mike,</div><div dir="ltr" class="gmail_attr"><br></div><div dir="ltr" class="gmail_attr">Den sön 2 aug. 2020 19:53Mike Beauchamp <<a href="mailto:list@mikebeauchamp.com" target="_blank" rel="noreferrer">list@mikebeauchamp.com</a>> skrev:<br></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">On 8/2/20 5:26 AM, Mattias Rickardsson wrote:<br>
> A heat camera can prove useful for design as well.<br>
<br>
Hi Mattais, I borrowed the FLIR for this exact reason - to check a <br>
prototype PCB design.<br>
<br>
The first thing I noticed was that all of my IC's get very hot. TL074's <br>
are all going up to around 50C in 20 minutes, NE5532 a bit hotter and <br>
the LM13700's stay pretty chilly. After running the board for about 20 <br>
minutes, the whole thing is warm to the touch - something I'm not really <br>
used to in previous designs. But this is my first surface-mount design <br>
and it is probably twice as dense as previous stuff. I'm using a +/-15V <br>
power supply.<br></blockquote></div></div><div dir="auto"><br></div><div dir="auto">Around 50 degrees is what I'm experiencing as well on TL074s on densely mounted double-sided SMT designs at +/-12 V supplies. At first quite unexpected since we're used to old hole-mount synth circuits not going very warm at all, but when measuring the current draw and summing up the expected supply currents of all circuits it seems to be correct. I guess the density is the main reason here, both having the heat sources much closer to each other AND having much smaller area & less material for dissipating the heat.</div><div dir="auto"><br></div><div dir="auto">Btw, TL064s are hardly visible in the heat camera - they pull so little current. Applying TL064 op-amps where noise & slewrate aren't critical factors is an important trick in designs where power & heat & cost are.</div><div dir="auto"> </div><div dir="auto"><div class="gmail_quote"><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">I checked the datasheet for the TL074 I'm using and it's "Operating <br>
Temperature" is 70C Maximum. I can't help being worried that my measured <br>
50C is pretty close to this, although I'm 95% certain I'm not doing <br>
anything electronically "wrong" with all of these chips to put them in <br>
danger.<br>
<br>
Maybe "Operating Temperature" refers to the ambient temperature that the <br>
chips can operate in, not the temperature they reach?<br></blockquote></div></div><div dir="auto"><br></div><div dir="auto">It would be very hard to actually measure the temperature on the hottest spot on (or even in) an IC, so from a design perspective I just assume that "Operating Temperature" refers to the surrounding air and PCB - and then the internal IC temperature lands on some reasonably well-known temperature above this, since the delta temperature is given by the expected power draw of the IC. Please do chime in, if someone can correct or clarify this! :-)</div><div dir="auto"><br></div><div dir="auto">/mr</div></div>