<div><div dir="auto">Aka veroboard.</div></div><div dir="auto"><br></div><div dir="auto">Regards,</div><div dir="auto">JPS</div><div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Wed, 29 Jul 2020 at 7:06 am, Jay Schwichtenberg <<a href="mailto:jschwich53@comcast.net">jschwich53@comcast.net</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">It's a PCB with holes on a 0.1" grid and copper strips on the bottom. <br>
You do a layout sort of like a PCB cutting the strips where it is <br>
needed. There are a number of ways to cut the strips. There is a tool <br>
made for it, I use a 3/32" drill bit in a pin vise or X-acto knife.<br>
<br>
You can do a search online for it. I use this software for layout, it's <br>
pretty basic but it works.<br>
<br>
<a href="http://diy-fever.com/software/diylc/" rel="noreferrer" target="_blank">http://diy-fever.com/software/diylc/</a><br>
<br>
I would recommend buying good FR4 boards. There are a lot of cheap ones <br>
out there made with phenolic or what they call bakelite with poor drill <br>
registration. I buy BusBoard ST2 and ST3.<br>
<br>
Jay S.<br>
<br>
On 7/28/2020 10:50 AM, Kenny Balys wrote:<br>
><br>
> What is strip board? That does sound like something I would like.<br>
><br>
> The 3M scotchflex socket system was eye wateringly expensive.<br>
> It made a lot of sense when prototyping digital bus based systems.<br>
><br>
> I made a lot of Eurorack size cards for GESBUS/Half VME, etc. that<br>
> would be alpha trialed before an actual PCB was made.<br>
><br>
> The comments here so far show that most of the reasons for its existence<br>
> are now gone.<br>
><br>
> Now, about this strip board, is that a wire wrap thing? Or is it "push to<br>
> clip & contact" like the 3M stuff?<br>
><br>
><br>
_______________________________________________<br>
Synth-diy mailing list<br>
<a href="mailto:Synth-diy@synth-diy.org" target="_blank">Synth-diy@synth-diy.org</a><br>
<a href="http://synth-diy.org/mailman/listinfo/synth-diy" rel="noreferrer" target="_blank">http://synth-diy.org/mailman/listinfo/synth-diy</a><br>
</blockquote></div></div>