<div dir="ltr">Thanks for the link Vlad and I appreciate your answer Richie. The case is wood. I went ahead and connected the earth ground to the 0V of the secondary. Should I try to connect a gnd wire to the aluminum rails? That's the last question I have about this. I appreciate you all!<br></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Fri, Jul 3, 2020 at 5:06 PM Richie Burnett <<a href="mailto:rburnett@richieburnett.co.uk">rburnett@richieburnett.co.uk</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">Yes, the mains protective earth should be connected to the 0v output on the low-voltage side for safety, (and the enclosure if it is metal!) Otherwise one of the following scenarios can result in dangerous mains voltages appearing at the low voltage output:<br><br>1. A high-voltage mains wire becomes disconnected and comes into contact with one of the low-voltage wires on the secondary side of the transformer.<br>2. The transformer's primary/secondary insulation fails and they windings come into contact. <br>3. There is a high-voltage transient (potentially 1kv+) on the mains supply that could arc over to the secondary side wiring if creapage and clearance distances are not sufficient. <br><br>If the secondary side is earthed (grounded) any of these scenarios should result in either a blown mains fuse or a tripped circuit breaker. Either way the mains power is cut off due to the large fault current flowing to earth and nobody receives a nasty shock.<br><br>Only exception is if the transformer is Class 2 (double insulated.)  Many small wall wart power supplies are made this way. Often potted to ensure the high voltage and low voltage sides cannot come into contact, and prevent flashover etc.<br><br>-Richie,<br><br>Sent from my Xperia SP on O2<br><br>---- Shawn Rakestraw wrote ----<br><br><div dir="ltr"><div>Some of you may remember helping me learn how to design some PCBs a few months back. I have been using one of my homemade eurorack cases for a while now. To refresh the idea, it is essentially an electronotes design where a 24V center tapped transformer is regulated down to +12V and -12V.</div><div><br></div><div>My question is this - Should the ground pin of the power cord be connected to the center tap of the transformer? Currently, I have it connected to the "Earth" terminal of the power switch and it is also connected to the "Body" of the transformer, but I have left the center tap "Floating".</div><div><br></div><div>After putting a Make Noise Pressure Points module into the case and noticing what looks like a lot of noise on the signal, I think that maybe the earth ground should connect to the center tap and floating ground.</div><div><br></div><div>Thanks for your advice.</div><div><br></div><div>- Shawn<br></div></div>
</blockquote></div>