<div dir="ltr"><div>Some of you may remember helping me learn how to design some PCBs a few months back. I have been using one of my homemade eurorack cases for a while now. To refresh the idea, it is essentially an electronotes design where a 24V center tapped transformer is regulated down to +12V and -12V.</div><div><br></div><div>My question is this - Should the ground pin of the power cord be connected to the center tap of the transformer? Currently, I have it connected to the "Earth" terminal of the power switch and it is also connected to the "Body" of the transformer, but I have left the center tap "Floating".</div><div><br></div><div>After putting a Make Noise Pressure Points module into the case and noticing what looks like a lot of noise on the signal, I think that maybe the earth ground should connect to the center tap and floating ground.</div><div><br></div><div>Thanks for your advice.</div><div><br></div><div>- Shawn<br></div></div>