<div dir="ltr">Just to clarify, was the system and/or part known good when it shipped out? <div><br></div><div>Assuming it was, you mention the protection ESD diode and reverse protection but I wonder does the circuit have any other protection for voltages below ESD levels but over the safe maximum for the chip?<br><br> I see +/- 18V max listed on the datasheet I looked at. </div><div><br></div><div>That's just my first instinct, that someone plugged in something with too great of a potential and it damaged one of the two channels. </div><div><br>It's easy enough to test and there are very simple fixes if it is an issue (36V zener with a current limiting resistor in parallel with input is a very basic old school way to do it, plenty of smarter folks here on the list with better ideas and ways I'm sure) </div><div><br>Tom<br><br></div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Wed, Jun 24, 2020 at 1:23 PM Frédéric (Opensource) <<a href="mailto:marzacdev@gmail.com">marzacdev@gmail.com</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">Hi to everyone,<br>
<br>
In a client audio design, I used a NJM2068 dual op-amp<br>
as the input signal conditioner before the ADC circuit.<br>
<br>
The op-amp is powered with symmetrical supply rails (+12V, -12V)<br>
provided by the power bus of an eurorack system.<br>
Rails are protected by series shottky diodes therefore the<br>
case of a polarity reversal can be discarded I presume.<br>
<br>
Audio input has an ESD protection diode and the impedance<br>
between the + input of the amp and the input jack tip is about<br>
20k (resistor). The input is specified for "eurorack level" signals.<br>
<br>
Unfortunately, after the field tests, we got back one module<br>
whose input op-amp had a defective channel. Input signal would<br>
be saturated while being far away from the rails.<br>
<br>
Had any of you a bad experience with this component?<br>
<br>
I am also open for all suggestions about what wrong could<br>
have happened?<br>
<br>
Best from Bonn,<br>
Frédéric<br>
<br>
_______________________________________________<br>
Synth-diy mailing list<br>
<a href="mailto:Synth-diy@synth-diy.org" target="_blank">Synth-diy@synth-diy.org</a><br>
<a href="http://synth-diy.org/mailman/listinfo/synth-diy" rel="noreferrer" target="_blank">http://synth-diy.org/mailman/listinfo/synth-diy</a><br>
</blockquote></div>