<div dir="auto">I used to use a commercial press as well.  It had plates that were drilled to protect the pins and pressed a rubber faced pressure plate down.<div dir="auto"><br></div><div dir="auto">Worked every time.</div><div dir="auto"><br></div><div dir="auto">Now when I try pliers it never works.  </div><div dir="auto"><br></div><div dir="auto">The pressure has to be uniform.</div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Fri, 5 Jun. 2020, 7:39 am Steve Lenham, <<a href="mailto:steve@bendentech.co.uk">steve@bendentech.co.uk</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">On 04/06/2020 21:12, gm wrote:<br>
> Hello-<br>
> I have to make about ten ribbon cable connectors with .6" 28 pin DIP <br>
> headers on either end.<br>
> I've tried using and IDC crimping tool with less than stellar results.<br>
> Is there a device or technique for doing this that can give reliable <br>
> results?<br>
> Thanks.<br>
> ~GMM<br>
<br>
You don't specify what is unsatisfactory with the results from the crimp <br>
tool, so we don't know what needs to be improved upon, but I've always <br>
had acceptable results from a very basic technique: I put the pins of <br>
the DIP header into two stacked pieces of stripboard (US: perfboard) to <br>
protect them, then crimp the resulting sandwich in a small bench vice <br>
(US: vise) as if it were a normal IDC socket. Squeeze it up just a <br>
little, double-check that the ribbon is at right-angles, then finish the <br>
job.<br>
<br>
I'd love a proper bench press to do this, but they do not do anything <br>
very different - they just help a bit more with the alignment of the <br>
parts. I can't justify one for the little use it would get, but the <br>
Thomas & Betts/Ansley ones are worth looking out for.<br>
<br>
Cheers,<br>
<br>
Steve L.<br>
Benden Sound Technology<br>
_______________________________________________<br>
Synth-diy mailing list<br>
<a href="mailto:Synth-diy@synth-diy.org" target="_blank" rel="noreferrer">Synth-diy@synth-diy.org</a><br>
<a href="http://synth-diy.org/mailman/listinfo/synth-diy" rel="noreferrer noreferrer" target="_blank">http://synth-diy.org/mailman/listinfo/synth-diy</a><br>
</blockquote></div>