<div dir="ltr"><div>Maybe someone has some suggestions for me.</div><div><br></div><div>I'm blowing fuses on my "industrial" power supply. This is a salvaged +/-15v, 3a supply housed in a rugged metal enclosure. I've wired it up with a fuse on the AC mains side, and fuses on the +/-15v side. The AC/mains fuse is giving me grief. <br></div><div><br></div><div>Step1) I can turn the unit on, and everything is fine. My synth is only drawing 1/2 an amp (or nothing when disconnected). <br></div><div>Step2) Turn the unit off. At this point, I can remove the mains fuse, and test it: yes, still good. <br></div><div>Step3) Re-install fuse, switch on. Nothing. Remove fuse and test again, now it's blown.</div><div>Step4) Install new fuse. Go to Step1)</div><div><br></div><div>I haven't used the PSU much yet, but I've powered it on and off loads of times and this problem never manifested till now. The fuses are 2amp, 250v, which I think is fine, but here is maybe my mistake: they are quick blow type. I'm uncertain, though. Wondering if I need to try to find a fault in the PSU, or just order the new fuses. But why didn't those quick blow fuses break before?</div><div><br></div><div>Thanks for reading!</div><div>Colin<br></div><div><br></div><div><div><div><br>-- <br><div dir="ltr" class="gmail_signature" data-smartmail="gmail_signature"><div dir="ltr"><div><div dir="ltr"><div><div dir="ltr"><div><a href="https://www.instagram.com/colinmuirdorward/" target="_blank">https://www.instagram.com/colinmuirdorward/</a></div><div><a href="https://www.instagram.com/colinmuirdorward/" target="_blank">-<br></a></div><div><a href="https://www.instagram.com/ssdp_synthesis/" target="_blank">https://www.instagram.com/ssdp_synthesis/</a></div></div></div></div></div></div></div></div></div></div></div>