<div dir="ltr"><div>Hey All! I'm new to the list and this is my first question.<br></div><div><br></div><div>I want to dip into making some PCBs and possibly front panels. I am into eurorack, so that is what I will be aiming toward. I have been learning how to use Eagle to make my schematic into a board.</div><div><br></div><div>Currently, I have been working on a power supply PCB that would mount inside of a case, so I don't have any major size constraints or precision. I will probably make a simple bus board next to distribute the power. Then I want to move on to an actual module. Something simple at first.</div><div><br></div><div>I should also mention that I am in USA, although that probably doesn't matter that much anymore. I do prefer to order things in the US when I can though.</div><div><br></div><div>I am asking for any advice at all really. My question begins with who / where to order from, but after that I am a bit in the dark about what to even ask. I don't know if copper trace thickness should be a concern. Obviously with power PCBs and distribution boards you want wide traces and I have done some research to try to learn how wide for certain amp loads. Really, any advice will be good for me - anything that you wish you had known before your first order could be helpful.</div><div><br></div><div>Has anyone made panels and if so, what is the beginning process for that? Can you design them in Eagle using Nets or something? I don't know how people even design them.</div><div><br></div><div>Thanks in advance, I look forward to your replies!</div><div><br></div><div>- Shawn<br></div></div>