<div dir="auto"><div><div class="gmail_quote"><div dir="ltr" class="gmail_attr">Den lör 2 nov. 2019 03:33 <<a href="mailto:mskala@ansuz.sooke.bc.ca">mskala@ansuz.sooke.bc.ca</a>> skrev:<br></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">On Sat, 2 Nov 2019, Adam Inglis wrote:<br>
> > It's worth pointing out that when the SMPS breaks you don't repair it<br>
><br>
> > You can always repair a linear mode PS.<br>
><br>
> Exactly!<br>
> Not doing the planet much good is it?!!<br>
<br>
Both devices will be thrown out eventually.  The linear regulator,<br>
being less efficient, is burning a lot more energy every moment it's<br>
in operation, and requires the transformer and so on upstream of the<br>
regulator to be larger to supply that power.  Pretty hard to spin that<br>
as an environmental win.<br></blockquote></div></div><div dir="auto"><br></div><div dir="auto">True, in the parts of the world where houses need cooling or in older buildings where the heat is thrown out with the ventilation. Excessive power draw is - and should be - then considered a waste of energy.</div><div dir="auto"><br></div><div dir="auto">In modern heated houses it's harder to tell, since the heat energy isn't wasted but mostly recirculated via ventilation and/or tap water.</div><div dir="auto"><br></div><div dir="auto">This direct electrical heat can often be the least efficient heat source, returning less than electrically powered heat pumps, but if it's produced locally by solar panels it might be more of a tie.</div><div dir="auto"><br></div><div dir="auto">Even if a linear PS is wasting 3 times as much energy as a SMPS, the synth (etc) draws 3 times more power than that bad old linear PS. All of this of course ends up as heat, so the comparison should probably be made not between linears & switchers wasting 30 or 10 % of their energy (a factor of 3), but between the whole systems using 70 or 90 % of their energy (not even close to a factor of 2).</div><div dir="auto">The building where the product is used also affects the equation, as mentioned above.</div><div dir="auto"><br></div><div dir="auto">Perhaps the design of the powered unit should be scrutinized more often. Using TL06x instead of TL07x op-amps, or using +/- 9 V instead of +/- 15 V supplies, can reduce more waste than going from linears to switchers.</div><div dir="auto"><br></div><div dir="auto">I'm not saying that linears are better, just that it's becoming more difficult to say that they are worse. The best supply would be an efficient switcher with low noise and long lifespan. :-)</div><div dir="auto"><br></div><div dir="auto">/mr - we've had frosty mornings this week, so heat is nice 8-)</div><div dir="auto"><div class="gmail_quote"><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">
</blockquote></div></div></div>