<div>The 10-turn would just be for the slider mechanism. I'd use a normal pot on the slider shaft/lever. The 10-turn will keep the gears much smaller - you're thinking 5-10 inches of travel, right? For a single turn 300-degree travel pot, or whatever, that'd require a large gear reduction. So the 10-turn isn't really for precision of resolution, as they're normally used like on VCOs or something but for increased travel and minimal real-estate for mechanical components. The idea is that over the whole length of travel of the mechanism the 10-turn pot would make it through all 10-turns, minus a bit of waste at the beginning and end that'd need to get trimmed out in the rest of the circuitry (anyway you'd probably want to have the waste on a single turn pot).<br></div><div class="protonmail_signature_block protonmail_signature_block-empty"><div class="protonmail_signature_block-user protonmail_signature_block-empty"><div><br></div></div><div class="protonmail_signature_block-proton protonmail_signature_block-empty"><br></div></div><div><br></div><div>‐‐‐‐‐‐‐ Original Message ‐‐‐‐‐‐‐<br></div><div> On Monday, June 10, 2019 3:59 PM, Pete Hartman <pete.hartman@gmail.com> wrote:<br></div><div> <br></div><blockquote class="protonmail_quote" type="cite"><div dir="ltr"><div dir="ltr"><br></div><div><br></div><div class="gmail_quote"><div dir="ltr">On Mon, Jun 10, 2019 at 2:54 PM thresholdpeople <<a href="mailto:thresholdpeople@protonmail.com">thresholdpeople@protonmail.com</a>> wrote:<br></div><blockquote style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex" class="gmail_quote"><div><br></div><div>And personally I'd use a 10-turn pot over an encoder. The circuitry will be far simpler.<br></div></blockquote><div><br></div><div><div>the primary goal is being able to smoothly adjust two parameters at the same time.  10-turn pots don't really enable that in my experience, quite the opposite.<br></div><div><br></div><div>If you put it on the pulley, then honestly it's not any better than a standard pot with appropriate gearing to make a full throw go from CCW to CW.<br></div></div><div><br></div><div> <br></div></div></div></blockquote><div><br></div>