<div dir="ltr">The common approach is to use kynar-coated wire wrap wire. This should be stripped before soldering, not soldered over. Staked down properly this is spaceflight certified by NASA, so it's good enough for me!<div><br></div><div>You can still get the wire easily, though I suspect that hardly anyone actually uses it for wire wrapping any more. I used to use it a lot when I was at NASA because kynar is vacuum-certified, so I used to use it to make temporary wiring harnesses for testing instruments in vacuum chambers. I generally would always solder it under a microscope in order to be certain of good joints, however, because it's usually a bit fine to see with the naked eye well enough to do a proper inspection.</div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Sun, Apr 7, 2019 at 10:27 PM Eric Frampton <<a href="mailto:eric@ericframpton.com">eric@ericframpton.com</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">Hi folks -<br>
<br>
Just to put a button on this thread, I think what I saw was the RoadRunner wire with the meltable/self-fluxing coating. At least, that fits the description best.<br>
<br>
Thanks for all the guidance!<br>
<br>
e<br>
<br>
<br>
_______________________________________________<br>
Synth-diy mailing list<br>
<a href="mailto:Synth-diy@synth-diy.org" target="_blank">Synth-diy@synth-diy.org</a><br>
<a href="http://synth-diy.org/mailman/listinfo/synth-diy" rel="noreferrer" target="_blank">http://synth-diy.org/mailman/listinfo/synth-diy</a><br>
</blockquote></div><br clear="all"><div><br></div>-- <br><div dir="ltr" class="gmail_signature">[s]</div>