<div dir="auto">Also sometimes 1k resistors in front of TL07/8xs are used to prevent phase-reversal...</div><br><div class="gmail_quote"><div dir="ltr">pe 26. lokak. 2018 klo 7.02 Tony K <<a href="mailto:weplar@gmail.com">weplar@gmail.com</a>> kirjoitti:<br></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">If you look on monosynth schematics manufacturers often used 1 K resistors to feed subsequent stages. as load resistors. Especially some sort of signal mixing was desired ( transistor circuits without op-amps did used this cost cutting measure see early Roland drum machines for example) <br>
<br>
TK<br>
<br>
> On Oct 25, 2018, at 11:00 PM, <a href="mailto:mskala@ansuz.sooke.bc.ca" target="_blank" rel="noreferrer">mskala@ansuz.sooke.bc.ca</a> wrote:<br>
> <br>
>> On Thu, 25 Oct 2018, Youssef Menebhi wrote:<br>
>> Sorry, but I just need to clarify the exceptions:<br>
>> The idea is that the "inputs" that are being fed by the output of the<br>
>> single op-amp will serve ultimately as outputs from the device.  So,<br>
>> buffers are needed?<br>
> <br>
> If there are voltage dividers between the op amp output and the outside<br>
> world, that's probably going to be enough to prevent the outside loads<br>
> from affecting each other through the op amp output.  What I was<br>
> imagining as a problem would be if you had something like the op amp<br>
> output connected *directly* to an output jack, and also to internal<br>
> stuff - in that case, someone plugs a short into the output jack and then<br>
> no signal gets to the other internal destinations either.<br>
> <br>
> But what are you actually building?  Some sort of interface?  Are you sure<br>
> your voltage dividers are going to present the right impedance to the<br>
> outside world?  That seems to me more likely to be an issue than the<br>
> internal connection between the op amp and the three voltage dividers,<br>
> which would normally be just a wire and not require any special design<br>
> of its own.<br>
> <br>
> -- <br>
> Matthew Skala<br>
> <a href="mailto:mskala@ansuz.sooke.bc.ca" target="_blank" rel="noreferrer">mskala@ansuz.sooke.bc.ca</a>                 People before tribes.<br>
> <a href="http://ansuz.sooke.bc.ca/" rel="noreferrer noreferrer" target="_blank">http://ansuz.sooke.bc.ca/</a><br>
> _______________________________________________<br>
> Synth-diy mailing list<br>
> <a href="mailto:Synth-diy@synth-diy.org" target="_blank" rel="noreferrer">Synth-diy@synth-diy.org</a><br>
> <a href="http://synth-diy.org/mailman/listinfo/synth-diy" rel="noreferrer noreferrer" target="_blank">http://synth-diy.org/mailman/listinfo/synth-diy</a><br>
<br>
_______________________________________________<br>
Synth-diy mailing list<br>
<a href="mailto:Synth-diy@synth-diy.org" target="_blank" rel="noreferrer">Synth-diy@synth-diy.org</a><br>
<a href="http://synth-diy.org/mailman/listinfo/synth-diy" rel="noreferrer noreferrer" target="_blank">http://synth-diy.org/mailman/listinfo/synth-diy</a><br>
</blockquote></div>