<div dir="ltr">Optical detection? I'm thinking a 3D printed part that is held in place by the jack, has a fitting for an LED on one side and a phototransistor on the other, and covers most of the jack to block out most ambient light (use IR LED and transistor for a little extra rejection of ambient light, maybe even SMT parts for maximum smallness). <div><br></div><div>Mechanical? A small tact switch engaged by the tip of the jack or a moving contact of the jack itself.</div><div><br></div><div>Magical? A Tiny Wizard (tm) that relays the jack status back to his other Tiny Wizard Brothers and Sisters (tm) back on the main board.</div><div><br></div><div><br></div><div>Tim (maybe the Harry Potter binge weekend is affecting me) Servo</div><div class="gmail_extra"><div><div class="gmail_signature" data-smartmail="gmail_signature"><div dir="ltr"><div><div dir="ltr">---<br>"Imagination is more important than knowledge." - Albert Einstein<br><br><br><br></div></div></div></div></div>
<br><div class="gmail_quote">On Mon, Jul 23, 2018 at 2:21 PM, Tim Ressel <span dir="ltr"><<a href="mailto:timr@circuitabbey.com" target="_blank">timr@circuitabbey.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">Hello supremely helpful folks!<br>
<br>
I've got another challenge: how to detect when a plug is inserted into a jack. These are 3.5mm mono jacks btw. The current method is to use a stereo jack. When a mono plug is inserted the ring connection gets shorted to ground by the sleeve of the plug. This method works well, but the stereo jacks are taller than the mono jacks.<br>
<br>
The only jack I can use is a switched mono jack where switched port is tied to the tip port until a plug is inserted. My idea is to use the switch port to feed an out of range voltage to the tip port, probably a negative voltage. Then use a comparator to detect when the tip port goes high.<br>
<br>
Any other thoughts?<span class="HOEnZb"><font color="#888888"><br>
<br>
-- <br>
--Tim Ressel<br>
Circuit Abbey<br>
<a href="mailto:timr@circuitabbey.com" target="_blank">timr@circuitabbey.com</a><br>
<br>
______________________________<wbr>_________________<br>
Synth-diy mailing list<br>
<a href="mailto:Synth-diy@synth-diy.org" target="_blank">Synth-diy@synth-diy.org</a><br>
<a href="http://synth-diy.org/mailman/listinfo/synth-diy" rel="noreferrer" target="_blank">http://synth-diy.org/mailman/l<wbr>istinfo/synth-diy</a><br>
</font></span></blockquote></div><br></div></div>