<div dir="ltr"><div class="gmail_extra"><div class="gmail_quote">On 26 May 2018 at 19:51, Roman <span dir="ltr"><<a href="mailto:modular@go2.pl" target="_blank">modular@go2.pl</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><br>And yet another idea to make it faster for higher frequencies and slower at the low end - make two such mute citrcuits pulling down one signal line - one FET gets the signal on its drain via capacitor, and its muting RC time constant is short, so high frequrncies are muted quickly, while low end doesn't care about that little cap and carries on. Then second FET hits in, with longer time constant RC. Without any cap it clamps everything to GND. <br></blockquote><div><br></div><div>True, what you really would need is a sweeping filter that opens/closes the high frequencies quicker than the lows. This means that turning the signal "on" is like sweeping a HPF from high frequencies and down, whereas turning the signal "off" is like sweeping a LPF from high frequencies and down. Makes for a great electronics exercise! ;-)</div><div><br></div><div>But - for optimum timing of all frequencies it's not an ordinary filter sweep where the cutoff frequency is moving, but a filter that gradually alters its slope. :-S</div><div><br></div><div>/mr</div><div><br></div></div></div></div>