<p dir="ltr">Who said everything has to be digital? Just the output must be digital. You could use an ADC and DAC to bridge over the bus.</p>
<p dir="ltr">And yeah, 1.8V, doesn't matter for the inner life of the chip anyways, it's not like you must run synth circuits at +/-15V</p>
<br><div class="gmail_quote"><div dir="ltr">On Tue, 1 May 2018 16:26 Eric Brombaugh, <<a href="mailto:ebrombaugh1@cox.net">ebrombaugh1@cox.net</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">On 05/01/2018 07:16 AM, Neil Johnson wrote:<br>
> Hi,<br>
> <br>
> On 1 May 2018 at 12:55, cheater00 cheater00 <<a href="mailto:cheater00@gmail.com" target="_blank">cheater00@gmail.com</a>> wrote:<br>
>> So apparently the people behind RISC V want to start a service where you can<br>
>> send your chip designs in and get them made. I wonder if this would be<br>
>> useful for analog.. this could really launch analog synths into the<br>
>> stratosphere. Perfect replacements for old rare chips, great new designs,<br>
>> better OTAs, oscillators, envelopes, amps... sounds almost too good to be<br>
>> true, so there's good reason to follow this.<br>
>><br>
>> Bear in mind this has loads of transistors.. so you could easily fit<br>
>> multiple (16? 64?) complex synth voices plus fx plus a micro to control them<br>
>> on one $100 chip and have all sorts of IO, too (probably best muxed as a<br>
>> single serial line to use as few pins as possible)<br>
>><br>
>> <a href="https://hackaday.io/project/152709-itsy-chipsy-make-your-own-100-chip" rel="noreferrer" target="_blank">https://hackaday.io/project/152709-itsy-chipsy-make-your-own-100-chip</a><br>
> <br>
> It is supposedly 180nm.  In which case forget about anything above a<br>
> few volts (typically 1.8V, or maybe up to 5V if you really push it).<br>
> <br>
> <a href="http://www.onsemi.com/PowerSolutions/content.do?id=16678" rel="noreferrer" target="_blank">http://www.onsemi.com/PowerSolutions/content.do?id=16678</a><br>
<br>
Also - $100 gets you 1/64th of the whole die and *no* I/O pins (you must <br>
share the common power/SPI/JTAG buses).<br>
<br>
Thanks, but if I'm going to have to do everything digital anyway I'll <br>
stick with cheap FPGAs - at least there I can iterate a design without <br>
blowing a hundred bucks for every pass.<br>
<br>
Eric<br>
_______________________________________________<br>
Synth-diy mailing list<br>
<a href="mailto:Synth-diy@synth-diy.org" target="_blank">Synth-diy@synth-diy.org</a><br>
<a href="http://synth-diy.org/mailman/listinfo/synth-diy" rel="noreferrer" target="_blank">http://synth-diy.org/mailman/listinfo/synth-diy</a><br>
</blockquote></div>