<div dir="ltr">I did a couple runs of aluminum PCB material with All PCB (<a href="http://allpcb.com">allpcb.com</a>).  For prototyping, good enough, but the tolerances were sloppy.  In one case I had a bit shaved off the last inch or so of one side -- enough that you'd see a noticeable gap with two panels next to each other.  In the other case, the silkscreen was smeary.  In both cases, the mounting holes were kinda sloppy too.<br><br>I was putting silkscreen on the aluminum side (back side), perhaps going onto the mask side it would be better, but the sloppy holes and other tolerances are such that I don't think I'm going to do any real runs like this.<br><br>I've also done one run of regular PCB material panels with OSH, but they're not someone I'd do bulk orders with due to cost.  The results were very nice (though purple).<div><br></div><div>Pete<br><br><br><br></div></div><div class="gmail_extra"><br><div class="gmail_quote">On Tue, Apr 24, 2018 at 5:39 PM, Chris McDowell <span dir="ltr"><<a href="mailto:declareupdate@gmail.com" target="_blank">declareupdate@gmail.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">Has anyone here tried doing panels with PCBs? I've had metalphoto screw up enough orders that I'm ready to try something else! They're not -terrible- but they can't guarantee a tight tolerance and it always bugs me at least, drives me nuts at the most. <br>
<br>
If you've given it a shot, where has it worked out for you? <br>
<br>
Cheers, <br>
Chris <br>
______________________________<wbr>_________________<br>
Synth-diy mailing list<br>
<a href="mailto:Synth-diy@synth-diy.org">Synth-diy@synth-diy.org</a><br>
<a href="http://synth-diy.org/mailman/listinfo/synth-diy" rel="noreferrer" target="_blank">http://synth-diy.org/mailman/<wbr>listinfo/synth-diy</a><br>
</blockquote></div><br></div>