<div dir="auto">Assuming you are designing for audio, isn't 3 Mohm a bit too noisy?<div dir="auto"><br></div><div dir="auto">/mr </div><div dir="auto"><br></div></div><div class="gmail_extra"><br><div class="gmail_quote">Den 30 dec. 2017 10:39 skrev "David G Dixon" <<a href="mailto:dixon@mail.ubc.ca">dixon@mail.ubc.ca</a>>:<br type="attribution"><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">So, after much cogitation, I'm thinking that I may just do this the other<br>
way round.  Instead of trying to keep my resistances within a certain range<br>
(around 30k) with all different capacitor values, I could use the same<br>
capacitor value for all 12 stages.<br>
<br>
If I used 10nF, then the resistances would range from about 374 ohms to<br>
about 3.01M.  These values fall within the range where I could use one or<br>
two standard 1% resistors to achieve the value within about 0.01% of the<br>
target.  The advantage is that 10nF falls within the range of C0G caps,<br>
which are standard 5% tolerance (and often significantly better).  Plus,<br>
there is the added convenience of only having to deal with one value of<br>
capacitor.  I could buy a pile of these (I can get them for 12 cents apiece<br>
at my local shop) and sort them into groups.  This is a value that my DVM<br>
reads quite accurately, so that's easy enough to do.<br>
<br>
The beauty of this is that I can actually build it in different ways and try<br>
them out.<br>
<br>
______________________________<wbr>_________________<br>
Synth-diy mailing list<br>
<a href="mailto:Synth-diy@synth-diy.org">Synth-diy@synth-diy.org</a><br>
<a href="http://synth-diy.org/mailman/listinfo/synth-diy" rel="noreferrer" target="_blank">http://synth-diy.org/mailman/<wbr>listinfo/synth-diy</a><br>
</blockquote></div></div>