<div dir="auto">I remember discussing this very topic on the midi forum years ago....and it took them until last year to finally publish something. <div dir="auto"><br></div><div dir="auto">If I remember rightly it was on a thread about drawing power from MIDI.</div><div dir="auto"><br></div><div dir="auto">Neil </div></div><div class="gmail_extra"><br><div class="gmail_quote">On 11 Aug 2017 15:26, "MTG" <<a href="mailto:grant@musictechnologiesgroup.com">grant@musictechnologiesgroup.com</a>> wrote:<br type="attribution"><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">
  
    
  
  <div text="#000000" bgcolor="#FFFFFF">
    <div class="m_-6409282404445128349moz-text-flowed" style="font-family:-moz-fixed;font-size:14px" lang="x-unicode">Maybe I'm the last to know, but
      there appears to be an official word on this:
      <br>
      <br>
      <a class="m_-6409282404445128349moz-txt-link-freetext" href="https://mitxela.com/other/ca33.pdf" target="_blank">https://mitxela.com/other/<wbr>ca33.pdf</a>
      <br>
      <br>
      I know people have been doing their own thing regarding the series
      resistors for the current loop.  I also noticed this caveat here:
      <br>
      <br>
      <a class="m_-6409282404445128349moz-txt-link-freetext" href="https://www.midi.org/forum/492-certain-midi-equipment-for-3-3v" target="_blank">https://www.midi.org/forum/<wbr>492-certain-midi-equipment-<wbr>for-3-3v</a>:
      <br>
      <br>
      "The MIDI specification specifies a 5 mA current loop, and shows
      three 220 Ω resistors to limit the current when used with a 5 V
      transmitter.
      <br>
      <br>
      When you have a 3.3 V transmitter, the two resistors in the
      transmitter must be smaller to get the same current, as shown in
      the Electrical Specification Update.
      <br>
      <br>
      The receiver does not need to know what voltage the transmitter
      uses; it always uses the same 220 Ω resistor. All transmitters are
      designed to work with that same receiver circuit. This means that
      all transmitters and receivers are compatible.
      <br>
      <br>
      (The receiver can use either 5 V or 3.3 V as supply for the
      optoisolator; this part of the circuit is isolated from the
      current loop, and does not affect compatibility of the MIDI
      interface. But note that only the PC900/H11L1 optoisolators can
      run at 3.3 V; other common models like the 6N137 or 6N138 require
      5 V.)"
      <br>
      <br>
    </div>
  </div>

<br>______________________________<wbr>_________________<br>
Synth-diy mailing list<br>
<a href="mailto:Synth-diy@synth-diy.org">Synth-diy@synth-diy.org</a><br>
<a href="http://synth-diy.org/mailman/listinfo/synth-diy" rel="noreferrer" target="_blank">http://synth-diy.org/mailman/<wbr>listinfo/synth-diy</a><br>
<br></blockquote></div></div>