<div dir="ltr">Hello!<div>I am working on a Polysix with a very bad case of battery leak damage.</div><div>I did my best to restore it with the Old Crow method and put the board back in and hooked everything up. Lots of work!</div><div><br></div><div>Upon test power-up it immediately makes a synth noise, but does not respond properly to keyboard input. The rate LEDs blink, and the preset 1 is active, volume control works, pitch wheel works, etc.</div><div>Upon switching to manual mode, however, nothing happens at all.</div><div><br></div><div>While prodding around I then noticed the panel and all grounds were electrified (because they shocked me)! Unplugging the transformer assembly from the<i> second</i> power PCB (with the large capacitors - filter PCB?) and thus presumably from the synth boards, and powering on still electrifies ground, so it must be earlier up the chain? The only thing I see touching ground on the first power PCB/transformer is a ground lug.</div><div><br></div><div>Does anyone have any suggestions and/or stupid things to check?</div><div><br></div><div>Should I harass Karl Ekdahl to fix it for me? :)</div><div><br></div><div>Regards,</div><div>Ian</div></div>